CyberData 011214 Operation Manual page 49

2. On the Security page, you may enter values for the parameters indicated in
Note
Web Page Item
Security Settings
ID
Name
Code
Valid From
Valid To
Blacklist
Relay Settings
Activate Relay on Valid Code
Activate DSR on Valid Code
Relay Timeout (seconds)
Audio Settings
Play tone while Relay Active
Play tone on Invalid Code Entry
Sensor Settings
Buzz on Door Open Timeout
Door Sensor Normally Closed
Sensor Open Timeout (in seconds)
DSR Open Timeout (in seconds)
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-12. Security Configuration Parameters
Description
Displays the ID associated with this security record.
Displays the name associated with this security record.
Displays the security code associated with this security record.
See Section 2.4.7.2, "The "Valid From" and "Valid To"
See Section 2.4.7.2, "The "Valid From" and "Valid To"
Displays the Blacklisted status of this security record. Blacklist is used to deny
entry to the specified security code. Entering a blacklisted code will trigger the
buzzer, and can trigger a call to an extension or a multicast of a pre-recorded
message.
Opens the
the Security Code
Removes the security code record.
Opens a new Configure Security Code window.
Activates the relay when a valid code is entered. This would likely be used to
open a door.
Activates the remote relay when a valid code is entered. This would likely be
used to open a door.
Specifies how many seconds the relay will be activated after a valid code
entry. In a typical use case, this would specify how long the door is unlocked.
When selected, an audible tone will indicate the relay is active.
When selected, a tone will play on the speaker to indicate an invalid code was
entered.
When selected, the buzzer will beep until the on board sensor is deactivated.
Select the inactive state of the door sensor. The door sensor is also known as
the Sense Input on the device's terminal block.
The time (in seconds) the device will wait before it triggers the buzzer when
the door sensor is active.
The time (in seconds) the device will wait before it triggers the buzzer when
the remote door sensor (DSR) is active.
931562B
Installing the SIP Outdoor Intercom with Keypad
) in the following table shows which web page items will be defined
.
Configure Security Code
Page".
Intercom Setup
Table
Settings".
Settings".
Page. See Section 2.4.7.1, "Configure
CyberData Corporation
42
2-12.