Beckman Coulter J-Lite JLA 16.250 Instruction Manual page 23

Small
O-Ring
(893503)
Large
O-Ring
(893502)
DECONTAMINATION
2
In U.S.A., contact Nuclear Associates (New York); in Eastern Europe and Commonwealth States, contact Victoreen GmbH (Munich);
in South Pacific, contact Gammasonics Pty, Ltd. (Australia); in Japan, contact Toyo Medic Co. Ltd. (Tokyo).
3
In U.S.A., contact Biodex Medical Systems (Shirley, NY); internationally, contact the U.S. office to find the dealer nearest you.
NOTE
Do not wash the rotor components or accessories
in a dishwasher. Do not soak components in
detergent solution for long periods of time, such
as overnight.
3. Thoroughly rinse the cleaned rotor and components with distilled
water.
4. Air-dry the rotor and lid upside down. Do not use acetone to dry
the rotor.
5. Apply a thin, even coat of silicone vacuum grease to the lid
O-rings and replace them in the grooves in the lid. Be careful
not to stretch, roll, or twist the O-rings during installation.
Clean metal threads every 6 months, or as necessary. Use a brush and
concentrated Solution 555. Rinse and dry thoroughly, then lubricate
lightly but evenly with Spinkote to coat all threads.
Periodically remove the O-rings and wipe clean as necessary. Clean
the O-ring grooves with a cotton-tipped swab. Reapply a light film of
silicone vacuum grease.
If the rotor (and/or accessories) becomes contaminated with radioac-
tive material, decontaminate it using a solution that will not damage
the anodized surfaces. Beckman Coulter has tested a number of
solutions and found several that do not harm anodized aluminum:
RadCon Surface Spray or IsoClean Solution (for soaking),
3
Radiacwash.
NOTE
IsoClean can cause fading of colored anodized
surfaces, such as the blue rotor lid. Use it only
when necessary and remove it promptly from
rotor surfaces.
J-Lite JLA-16.250 Rotor
2
and
23