Accessories/Scope Of Delivery; Storage And Transport - Synthes Battery Power Line II Instructions For Use Manual

Introduction
General Information

Accessories/scope of delivery

The Battery Power Line II consists of three different
handpieces, a battery casing, a battery and a range of
attachments designed for the system.
Please refer to the "Ordering Information" section on
page 84ff for an overview of the components of the
system.
To charge the batteries only use the corresponding
Synthes Universal Battery Charger II (05.001.204).
To reach the specified performance only Synthes cutting
tools should be used. These are optimized to meet the
specific requirements of the tool. Non Synthes saw
blades can considerably reduce the lifetime of the
system.
Special auxiliaries such as cleaning brushes (516.101) and
Synthes Special Oil (519.970) are available for cleaning
and servicing the system.
No oils from other manufacturers must be used. Only
Synthes Special Oil (519.970) must be used to lubricate
the power tools and attachments. Lubricants with other
compositions may cause jamming, have a toxic effect or
have a negative impact on the sterilization results. Only
lubricate the power tool, the battery casing and the at-
tachments when clean.
Synthes recommends the use of the specifically designed
Synthes Washing Baskets (68.001.620, 68.001.625) or
Synthes Vario Case (689.202) to sterilize and store the
system. Furthermore, the Washing Baskets (68.001.620,
68.001.625) can be used for the automated cleaning
procedure. Further information can be found on page
51ff.
6 DePuy Synthes Battery Power Line II Surgical Technique

Storage and transport

Only use the original packaging for dispatch and trans-
port as otherwise damage may occur. If the packing
material is no longer available, please contact your local
Synthes office.
Please refer to the guidelines for transporting Li-Ion
batteries when returning them to the Synthes Service
Center.
Do not store or transport batteries haphazardly in a box
or drawer where they may short-circuit each other or be
short-circuited by other metal objects. This can damage
the batteries and generate heat, which can cause burns.
For storage and transport environmental conditions
please refer to the section "System Specification" on
page 75.
Warranty/Liability
The warranty for the tools and accessories does not
cover damage of any kind resulting from wear, improper
use, improper reprocessing and maintenance, damaged
seal, use of non Synthes cutting tools and lubricants or
improper storage and transport.
The manufacturer excludes liability for damage resulting
from improper use, neglected or unauthorized mainte-
nance or servicing of the tool.
For further information on the warranty please contact
your local Synthes office.