Laser Safety - GE Medical Systems PRODIGY Service Manual

1.6.2 Laser safety

This document contains confidential or proprietary information of GE-Lunar Corp. Neither the document nor the information therein is
to be reproduced, distributed, used or disclosed, either in whole or in part, except as specifically authorized by GE-Lunar Corp.
PRODIGY Service Manual (Rev C - 2000)
Figure 1-7. Potential Pinch Points on the PRODIGY
The label that follows is located on the scanner arm and shows the location of
the laser aperture.
Do not touch the AC Surge Suppressor
(located on the AC terminal block) it
may be hot.
Do not electrically connect the isolation
transformer bolt head to ground, doing
this will short out the transformer
Scan table isolated outlet strip must be
appropriately connected.
DO NOT STARE INTO THE LASER BEAM
during patient positioning and Quality
Assurance procedures.
Safety1-23