Table of Contents
Advertisement
Chapter 2: Installation
56
5. Remove the dust cover from the SFP transceiver. Refer to Figure 23
Figure 23. Remove SFP Transceiver Dust Cover
6. Verify that the SFP handle is in the locked position. If the transceiver is
in a top slot, the handle should be in the upright position. Refer to
Figure 24. If the transceiver is in a bottom slot, the handle should be in
the down position.
Figure 24. Position SFP Handle in Locked Position
7. Repeat steps 1 through Step 6 to install an additional SFP transceiver.
8. Go to "Switch Cable Installation" on page 45.
Advertisement
Table of Contents
