Install At-Ie210L-10Gp Switch In Equipment Rack; Figure 12: Attach Rack Mount Brackets To At-Ie210L-10Gp Switch - Allied Telesis IE210L Series Installation Manual

Install AT-IE210L-10GP Switch in Equipment Rack

These instructions show you how to install an AT-IE210L-10GP switch in
an equipment rack with parts from the AT-RKMT-J14 Rack Mount Kit. This
kit is not supplied with the switch, however, it can be purchased separately
from your Allied Telesis dealer.
Note
This following procedure assumes that the rubber feet are not
installed on the bottom of the chassis. If the rubber feet are installed,
complete the procedure in "Remove Rubber Feet From Switch
Chassis" on page 40 before proceeding with the installation of the
switch into the equipment rack.
To install an AT-IE210L-10GP switch into a 19-inch equipment rack, follow
these steps using the brackets and screws supplied in the AT-RKMT-J14
rack mount kit:
1. Attach two rack mount brackets to the sides of the switch using eight
bracket screws . Refer to Figure 12.
Figure 12. Attach Rack Mount Brackets to AT-IE210L-10GP Switch
IE210L Series Industrial Gigabit Ethernet Switch Installation Guide
41