Remove Sfp Transceiver; Figure 25: Insert Sfp Transceiver Dust Cover; Figure 26: Position Sfp Handle In Unlocked Position - Allied Telesis IE210L Series Installation Manual

Remove SFP Transceiver

To remove a SFP transceiver from the IE210L chassis, perform the
following procedure:
1. Remove the cable installed in the SFP transceiver.
2. Insert the SFP transceiver dust cover into the SFP transceiver. Refer
to Figure 25.
Figure 25. Insert SFP transceiver Dust Cover
3. Unlock the SFP module by moving the handle. If the transceiver is in a
top slot, move the handle to the down position. Refer to Figure 26. If
the transceiver is in a bottom slot, move the handle to the upright
position.
Figure 26. Position SFP Handle in Unlocked Position
IE210L Series Industrial Gigabit Ethernet Switch Installation Guide
57