Initialize Remote Control - Valor LX2 Series Installation & Owner's Manual

QUALIFIED
INSTALLER

Initialize Remote Control

The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use.
The receiver is located on the bottom of the fi replace
behind the front panel under the valve heat shield. The
battery holder is located next to the wall switch.
Fireplace
Gas valve
Receiver
The receiver and gas valve are located on the bottom of the
fi replace behind the front panel under the valve heat shield.
The battery holder is located next to the wall switch.
1. Insert one 9 V alkaline battery in the handset.
2. Behind the front panel of the appliance, slide the
valve heat shield to the right and locate the receiver.
Detach it from the Velcro and pull it out.
Top view—Valve heat shield closed
Valve Receiver V-module
Top view—Slide valve heat shield opened
64
INSTALLATION
Battery
holder
& wall
switch
Valve heat shield
Valve heat shield
RESET
Reset button
3. Locate the Reset button on the top side of the
receiver.
4. With a sharp object, press and hold the receiver's reset
button until you hear one short and one long beeps.
Release the reset button after the second beep.
5. Within the subsequent 20 seconds, press the (small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the synchronization
is set.
This is a one time setting only and is not required
when changing the batteries in the remote battery
holder. The remote control system is now ready to
use.
6. Put the valve heat shield back in place, over the
valve, receiver and v-module.
WARNING
!
A LWAY S P U T T H E VA LV E H E AT S H I E L D
BACK IN PLACE over the valve, receiver and
v-module! Otherwise, the controls can overheat
and the fireplace stop working.
Valve heat shield