Initialize Remote Control - Valor L2 SERIES Installation & Owner's Manual

8. Disconnect the battery box wire if already connected.
9. Remove the cover of the battery box (1 screw).
10. Insert four AA alkaline batteries in the battery box,
refi t the cover and secure with the screw.
Note: Do not put batteries in the receiver, only in
the battery box.
11. Reconnect the battery box and
place it back in its carrier.

Initialize Remote Control

The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use.
1. Insert one 9 V alkaline battery in the handset.
2. Locate the Reset button on the top side of the
receiver.
3. With a sharp object, press and hold the receiver's reset
button until you hear one short and one long beeps.
Release the reset button after the second beep.
4. Within the subsequent 20 seconds, press the (small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the synchronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Installation
12. Slide the carrier towards
the right hand side so
that the battery box goes
outside of the appliance
case.
13. Test the operation of the
wall switch—see page 16.
14. Fix the wall cover plate to
the outlet box.
15. Replace the receiver in its position and as well as
the antenna if deployed.
To avoid short-circuit to the receiver, position
the antenna so that it DOES NOT TOUCH the
ignition wire.
Appliance's
front panel
QUALIFIED
INSTALLER
Slide the battery carrier
out of the appliance
CAUTION
Reset
button
Velcro
Battery box
connection
53