Installation; Unpack Appliance; Remove Base Plate And Window - Valor LX2 Series Installation & Owner's Manual

Please note that the LDK HeatShift
Duct Kit MUST be installed on this
appliance!

Unpack Appliance

Beware of sharp edges! Wear gloves!
1. Remove the wood pallet and packaging from the
appliance and discard. Keep the barrier screen in
its carton to avoid damaging it.
2. Unpack any loose items around the appliance.
3. Verify that you have all the components
required for the installation, including:
- approved non combustible cement board;
- liners and fuel bed (in separate cartons);
- barrier screen;
- venting components and accessories;
- LDK HeatShift Duct Kit components;
- electrical components.

Remove Base Plate and Window

1. Remove the base plate. From the fi replace's open
corner,
a) slide the plate sideways;
b) lift the plate up.

INSTALLATION

b
a
2. The window is held in place by two spring-loaded
levers on the top. Hook the window handle to one of
the spring-loaded window levers.
3. Pull the lever and unhook the window. Repeat with
the other lever.
4. Pull the top of the
window outward
and lift it up behind
the front panel to
disengage it from
its rail.
5. Once removed
from the bottom
rail, rotate the
window pane
outward to
take it out
completely;
set it aside in a
safe place to avoid
damage.
QUALIFIED
INSTALLER
41