Replacing Batteries; Using Remote Control Handset Wall Holder - Valor LX2 Series Installation & Owner's Manual

OWNER'S
INFORMATION

Replacing Batteries

The fi replace requires electrical power which will power
the upper lighting (supplied) as well as the remote
control receiver. The handset needs a battery.
If you wish to have batteries operating the
fi replace in case of a power outage, insert
batteries in the Remote battery and Wall
Switch (supplied) installed near the fi replace.
DO NOT PUT BATTERIES IN THE
RECEIVER OF THE FIREPLACE!
They will overheat and leak.
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery holder or
the handset! This could cause a short circuit.
Low batteries signal: see page 14.
BEFORE changing the batteries, turn the fi replace
off (including pilot).
The appliance uses four 1.5 V AA alkaline batteries
located next to the wall switch and one 9 V alkaline
battery in its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off -season will extend the battery life.
To replace the batteries:
The battery compartment is located next to the wall
switch in the vicinity of the fi replace. Its front plate is
attached with magnets to the wall switch box.
Fireplace
The battery holder is located beside the wall switch.
22
MAINTAINING YOUR FIREPLACE
Battery
holder &
wall switch
Battery
holder
& wall
switch
1. Pull on the plate next
to the wall switch to
access the batteries.
2. Disconnect the snap
connector from the
battery holder. Do not
pull the connector by
the wire!
3. Replace the batteries
with 4 AA alkaline
batteries orienting them
as indicated inside the
holder.
4. Reconnect the snap connector to the battery holder.
5. Put the battery holder back in its place beside the
wall switch and snap it in place.
Using Remote Control Handset Wall
Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn't been
installed, refer to the instructions further on
in this manual for the installation.
Disconnect
connector