Appendix A-Remote Control Operation - Valor 1100MN Owner's Manual

Appendix A-Remote Control Operation

Remote Control Operation
Note: Before using the remote control system for the first time, the receiver and the handset must be paired.
NOTE: Before using the remote control system for the first time, the receiver and the handset must be paired. See
See the Remote Control Setup section in the Installation Manual.
the section Remote Control Initial Pairing on the rst page of this manual.
Main Display
Child Proof
Countdown Timer
Program Mode
To Turn On Fire
NOTE: When pilot ignition is con rmed, motor
automatically turns to maximum ame height.
One-Button lighting (default):
Two-Button lighting:
simultaneously
Press and hold for 4 seconds, until 8
short beeps and a blinking series of
lines con rms the start sequence has
begun. Release button.
Main gas ows once pilot ignition is
con rmed.
Handset automatically goes into
manual mode after main burner
ignition.
Standby Mode (Pilot Flame)
Press and hold to set appliance to
pilot ame.
22
Time
ON
OFF
Temperature
+
Signal Indicator
Thermostatic Mode
AM
PM
Auxiliary Feature (not used)
CAUTION: If the pilot does not stay lit after
several tries call your local service technician or
gas supplier.
To Turn O Fire
Press to turn OFF.
Note: There is a 2 minute delay after
switching o before the next ignition is
possible.
CAUTION: Always check the re and pilot visu-
ally to ensure they are o .
Flame Height Adjustment
To increase ame height, press and
hold .
To decrease ame height, press and
hold . You may hold the button
down until the re is set to pilot ame
only.
Battery Status
Fan (if included)
°F or °C
Light
(not used)
Eco Mode
AM