First Operation - Valor LX2 Series Installation & Owner's Manual

4. Reinstall the base plate:
a) place the base plate on the fi replace's
front fl ange with the magnets behind the
fi replace's front panel;
b) ensuring the plate is lined up with the fl ange,
slide the plate sideways so both its ends butt
with the vertical panels of the black frame;
c) pull the plate forward so it is fl ush with the
fi replace's front fl ange.
INTRODUCTION
5. Reinstall the barrier screen:
a) place the side screen, magnets inboard,
against the ridge of the base plate;
b) push the top of the screen against the ridge of
the top plate.
c) place the front screen, magnets inboard,
against the ridge of the base plate;
d) push the top of the screen against the ridge of
the top plate.
c

First Operation

When operating your new fi replace for the fi rst time,
some vapors may be released due to the burning of
curing compounds used in the manufacture of the
appliance. They may cause a slight odor and could
cause the fl ames to be the full height of the fi rebox, or
even slightly higher, for the fi rst few hours of operation.
It is also possible that these vapors could set off any
smoke detection alarms in the immediate vicinity.
These vapors are quite normal on new appliances. We
recommend opening a window to vent the room. After
a few hours use, the vapors will have disappeared and
the fl ames will be at their normal height.
Flame Supervision Device
For your safety, this appliance is fi tted with a fl ame
supervision device which will shut-off the gas supply
if, for any reason, the pilot fl ame goes out. This device
incorporates a fi xed probe, which senses the heat
from the pilot fl ame. If the probe is cool, the device will
prevent any gas fl ow unless manually lighting the pilot.
See full lighting instructions on page 16 of this manual.
Performance of propane gas appliances may be
aff ected by the quality of commercial gas sup-
plied in your area.
OWNER'S
INFORMATION
d
b
a
7