Operating Your Fireplace; Fireplace Control Devices; How To Turn Your Fireplace Off (Including Pilot); How To Ensure Your Fireplace Cannot Be Turned On Inadvertently - Valor LX2 Series Installation & Owner's Manual

OWNER'S
INFORMATION

Fireplace Control Devices

There are two ways to control your fi replace.
1. Thermostatic Remote
Control;
2. Wall Switch.
The Thermostatic Remote
Control can be programmed
to function automatically—
see pages 9–14.
The Wall Switch can be used to turn on, off and to
increase or decrease the fl ame height—see page 15.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your fi replace.
Press and hold the OFF button for a second (either on
the handset or the wall switch).
Remote control handset
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
In the unlikely event that you cannot turn off your
fi replace with the remote control handset, use the
wall switch (if installed); if the wall switch malfunctions
and will not turn off the fi replace, wait 6 hours and the
fi replace will automatically go to pilot. You can then
access the controls inside your fi replace. Alternately,
turn off gas supply. In all cases, call your dealer for
service assistance.
ON: parallel to pipe
8

OPERATING YOUR FIREPLACE

Thermostatic
Wall Switch
Remote Control
Wall Switch
OFF:
perpendicular
to pipe
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
First, ensure your fi replace is turned off —including
the pilot—and cold BEFORE going ahead.
WARNING
!
RISKS OF SEVERE BURNS! SURFACES OF
THE FIREPLACE ARE VERY HOT DURING
OPERATION! Be very careful and wear gloves to
access controls.
Turn off gas supply to the fi replace. Access the gas
shut-off valve by removing the barrier screens and the
bottom black plate. The shut-off valve is located behind
the front panel on the left of the gas valve as indicated.
Fireplace
Gas
shut-off
valve Gas valve
Gas shut-off valve
Top view
Turn the shut-off valve from the ON position (handle
parallel) to the OFF position (handle perpendicular) as
shown. This will cut off the gas supply to the fi replace
and will ensure that the main burner can not come on.
NOTE: Ensure shut-off valve is turned back to
ON position (handle parallel) before operating
the fi replace.
Automatic Shut-Off
Your fi replace's remote control is equipped with an
automatic shut-off mechanism which is activated
in certain conditions. See page 14 in the Using the
Remote Control section for a description of this feature.
The gas
shut-off valve
is located
behind the
front panel,
left of the
gas valve.
(in certain conditions)