Package Management Procedures; Activation And Deactivation Prerequisites - Cisco ASR 9000 Series User Configuration Manual

Package Management Procedures

Install logs:
Package Management Procedures
Review the concepts about package management before performing the tasks described in this module.
Note
Related Topics
Information About Package Management, on page 25

Activation and Deactivation Prerequisites

These prerequisites must be met for a package to be activated or deactivated:
• You must be in a user group associated with a task group that includes the proper task IDs. The command
• Verify that all cards are installed and operating properly. For example, do not activate or deactivate
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
34
Install method: parallel
Summary of changes on nodes 0/1/SP, 0/6/SP, 0/SM0/SP, 0/SM1/SP,
0/SM2/SP, 0/SM3/SP:
Activated: asr9k-diags-3.7.2.1I
No processes affected
Summary of changes on nodes 0/1/CPU0, 0/6/CPU0:
Activated: asr9k-diags-3.7.2.1I
asr9k-mcast-3.7.2.1I
asr9k-mpls-3.7.2.1I
1 asr9k-mpls processes affected (0 updated, 1 added, 0 removed, 0 impacted)
2 asr9k-mcast processes affected (0 updated, 2 added, 0 removed, 0 impacted)
Summary of changes on nodes 0/RP0/CPU0, 0/RP1/CPU0:
Activated: asr9k-diags-3.7.2.1I
asr9k-k9sec-3.7.2.1I
asr9k-mcast-3.7.2.1I
asr9k-mgbl-3.7.2.1I
asr9k-mpls-3.7.2.1I
6 asr9k-mgbl processes affected (0 updated, 6 added, 0 removed, 0 impacted)
8 asr9k-mpls processes affected (0 updated, 8 added, 0 removed, 0 impacted)
7 asr9k-k9sec processes affected (0 updated, 7 added, 0 removed, 0 impacted)
14 asr9k-mcast processes affected (0 updated, 14 added, 0 removed, 0 impacted)
Install operation 2 'install activate disk0:asr9k-diags-3.7.2.1I
disk0:asr9k-k9sec-3.7.2.1I disk0:asr9k-mcast-3.7.2.1I disk0:asr9k-mgbl-3.7.2.1I
disk0:asr9k-mpls-3.7.2.1I' started by user 'labuser' at 18:06:32 UTC
Sat Jun 03 2006.
Info: The changes made to software configurations will not be
Info: persistent across system reloads. Use the command 'admin install
Info: commit' to make changes persistent.
Info: Please verify that the system is consistent following the
Info: software change using the following commands:
Info: show system verify
Info: install verify packages
Install operation 2 completed successfully at 18:07:48 UTC Sat Jun 03 2006.
reference guides include the task IDs required for each command. If you suspect user group assignment
is preventing you from using a command, contact your AAA administrator for assistance.
packages while cards are booting, while cards are being upgraded or replaced, or when you anticipate
an automatic switchover activity.
Upgrading and Managing Cisco IOS XR Software