Cisco ASR 9000 Series User Configuration Manual page 26

Configuring the Feature Profile
DETAILED STEPS
Command or Action
Step 1
admin
Example:
RP/0/RSP0/CPU0:router# admin
Step 2 configure
Example:
RP/0/RSP0/CPU0:router(admin)# configure
Step 3
hw-module profile feature{default | l2}
Example:
RP/0/RSP0/CPU0:router(admin-config)# hw-module
profile
feature l2
Wed Dec 8 08:29:54.053 PST
L2 feature profile does NOT support the following
features:
IPv6, RPF, Netflow.
In order to activate this new memory resource
profile,
you must manually reboot the line cards.
Step 4
commit
Step 5
reload location {all | node-id}
Example:
RP/0/RSP0/CPU0:router(admin)# reload location
0/0/cpu0
Step 6 show running-config
Example:
RP/0/RSP0/CPU0:router(admin)# show running-config
hw-module profile feature
Step 7 show hw-module profile feature
Example:
RP/0/RSP0/CPU0:router# show hw-module profile
feature all
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
8
Purpose
Enters administration EXEC mode.
Enters administration configuration mode.
Specifies the feature profile for the router.
• default—supports all features except provider
backbone bridge (PBB).
• l2—supports PBB, but does not support IPv6,
reverse-path forwarding (RPF) and netflow.
Reloads a line card. Before the feature profile configuration
becomes effective, you must reload all line cards in the
router. Use the reload location node-id command for each
line card separately.
Displays the configured feature profile.
Displays the active feature profile. If the active profile is
different from the configured profile, the line cards have
not been reloaded as required for the feature profile
configuration to take place.
Configuring Profiles