Implementing OnePK
Enabling onePK
Perform this task to enable onePK.
Note
Once the onep session is up, DPSS configuration is done from the application on the controller end.
SUMMARY STEPS
1. configure
2. onep
3. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
onep
Example:
RP/0/RSP0/CPU0:router (config) # onep
Step 3
commit
Configuring onePK
This procedure describes the steps involved in configuring the various onePK parameters.
The onePK commands used in this configuration procedure, are discussed in detail in the Cisco ASR 9000
Series Aggregation Services Router System Management Command Reference.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Purpose
Enters the onep configuration mode and enables onep. All
onePK attributes and parameters are configured in this
submode.
Enabling onePK
269