Configuring The Clock Interface For A Ptp Master - Cisco ASR 9000 Series User Configuration Manual
Aggregation services router
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Configuring PTP
Command or Action
Step 13
show run interface value
Example:
RP/0/RSP0/CPU0:router# show run interface
tengige0/1/0/5
Fri Aug
interface TenGigE0/1/0/5
ptp
profile tp64
transport ipv4
port state slave-only
master ipv4 1.7.1.2
!
announce timeout 2
!
ipv4 address 1.7.1.1 255.255.255.0
transceiver permit pid all
!
Configuring the Clock Interface for a PTP Master
Use these steps to configure a clock interface for the PTP master:
SUMMARY STEPS
1. configure
2. clock-interface sync value location node
3. port-parameters dti
4. frequency synchronization
5. selection input
6. priority number
7. wait-to-restore number
8. ssm disable
9. quality receive exact itu-t option number generation number PRS
10. Use one of these commands:
3 19:57:14.184 UTC
• end
• commit
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Configuring the Clock Interface for a PTP Master
Purpose
Displays the running configuration.
243
Advertisement
Table of Contents
Troubleshooting
