Cisco ASR 9000 Series User Configuration Manual page 262

Configuring the Clock Interface for a PTP Master
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 clock-interface sync value location node
Example:
RP/0/RSP0/CPU0:router(config)# clock-interface
sync 1
location 0/RSP0/CPU0
Step 3 port-parameters dti
Example:
RP/0/RSP0/CPU0:router(config-clock-if)#
port-parameters dti
Step 4 frequency synchronization
Example:
RP/0/RSP0/CPU0:router(config-clock-if)#
frequency synchronization
Step 5 selection input
Example:
RP/0/RSP0/CPU0:router(config-clk-freqsync)#
selection input
Step 6 priority number
Example:
RP/0/RSP0/CPU0:router(config-clk-freqsync)#
priority 10
Step 7 wait-to-restore number
Example:
RP/0/RSP0/CPU0:router(config-clk-freqsync)#
wait-to-restore 0
Step 8
ssm disable
Example:
RP/0/RSP0/CPU0:router(config-clk-freqsync)#
ssm disable
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
244
Purpose
Enters configuration mode for the specified clock interface.
Configures the port parameters for the clock interface.
Enters frequency synchronization mode for the clock interface.
Configures selection input for the clock interface.
Configures priority for the clock interface.
Configures the wait-to-restore time for the clock interface.
Disables SSM packets for the clock interface.
Configuring PTP