Cisco ASR 9000 Series User Configuration Manual page 191

Upgrading FPD
----------------------------------------------------------------------------------------------
SPA-OC192POS-XFP
----------------------------------------------------------------------------------------------
SPA-2XOC48POS/RPR
----------------------------------------------------------------------------------------------
SPA-8XOC3-POS
----------------------------------------------------------------------------------------------
SPA-10X1GE-V2
----------------------------------------------------------------------------------------------
SPA-5X1GE-V2
----------------------------------------------------------------------------------------------
SPA-1X10GE-L-V2
----------------------------------------------------------------------------------------------
SPA-4XOC3-POS-V2
----------------------------------------------------------------------------------------------
SPA-1X10GE-WL-V2
----------------------------------------------------------------------------------------------
This table describes the significant fields shown in the display:
Table 23: show fpd package Field Descriptions
Field
Card Type
FPD Description
Type
Subtype
SW Version
Min Req SW Vers
Min Req HW Vers
SPA ROMMON
SPA FPGA swv1.2 hwv2
SPA FPGA swv1.0
SPA FPGA swv1.0
SPA FPGA swv1.10
SPA FPGA swv1.10
SPA FPGA swv1.9
SPA FPGA swv1.0
SPA FPGA swv1.9
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
show fpd package Command Output: Example
spa rommon
spa fpga1
spa fpga1
spa fpga1
spa fpga1
spa fpga1
spa fpga1
spa fpga1
spa fpga1
Description
Module part number.
Description of all FPD images available for the SPA.
Hardware type. Possible types can be:
• spa—Shared port adapter
• lc—Line card
FPD subtype. These values are used in the upgrade
hw-module fpd command to indicate a specific FPD image
type to upgrade.
FPD software version recommended for the associated module
running the current Cisco IOS XR software.
Minimum required FPD image software version to operate
the card. Version 0.0 indicates that a minimum required image
was not programmed into the card.
Minimum required hardware version for the associated FPD
image. A minimum hardware requirement of version 0.0
indicates that all hardware can support this FPD image
version.
2.12 0.0 0.140
1.02 0.0
1.00 0.0
1.00 0.0
1.10 0.0
1.10 0.0
1.09 0.0
1.00 0.0
1.09 0.0
173
2.0
0.0
0.5
0.0
0.0
0.0
0.5
0.0