Implementing Physical And Virtual Terminals - Cisco ASR 9000 Series User Configuration Manual

Implementing Physical and Virtual Terminals

Line templates define standard attribute settings for incoming and outgoing transport over physical and
virtual terminal lines (vtys). Vty pools are used to apply template settings to ranges of vtys.
Note Before creating or modifying the vty pools, enable the telnet server using the telnet server command in
Global Configuration mode. See Cisco ASR 9000 Series Aggregation Services Router IP Addresses and
Services Configuration Guide and Cisco ASR 9000 Series Aggregation Services Router IP Addresses and
Services Command Reference for more information.
This module describes the new and revised tasks you need to implement physical and virtual terminals on
your Cisco IOS XR network.
For more information about physical and virtual terminals on the Cisco IOS XR software and complete
descriptions of the terminal services commands listed in this module, see
To locate documentation for other commands that might appear in the course of running a configuration
task, search online in Cisco ASR 9000 Series Aggregation Services Router Commands Master List.
Table 35: Feature History for Implementing Physical and Virtual Templates on Cisco IOS XR Software
Release
Release 3.7.2
This module contains the following topics:
•
•
•
•
•
•
Modification
This feature was introduced.
Prerequisites for Implementing Physical and Virtual Terminals, page 344
Information About Implementing Physical and Virtual Terminals, page 344
How to Implement Physical and Virtual Terminals on Cisco IOS XR Software, page 346
Craft Panel Interface, page 350
Configuration Examples for Implementing Physical and Virtual Terminals, page 350
Additional References, page 352
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
18
C H A P T E R
Related Documents, on page 352.
343