Prerequisites For Managing Router Hardware - Cisco ASR 9000 Series User Configuration Manual

Prerequisites for Managing Router Hardware

Prerequisites for Managing Router Hardware
You must be in a user group associated with a task group that includes the proper task IDs. The command
reference guides include the task IDs required for each command. If you suspect user group assignment is
preventing you from using a command, contact your AAA administrator for assistance.
Displaying Hardware Status
This section describes how to display different types of hardware status information.
Displaying SDR Hardware Version Information
To display hardware version information for the components assigned to a secure domain router (SDR),
connect to the designated shelf controller (DSC) and enter the show diag command in EXEC mode. The
displayed information includes the card serial number and the ROMMON software version.
The syntax for the show diag command in EXEC mode is:
show diag [node-id | details | summary]
In the following example, the show diag command displays information for all nodes in the SDR:
RP/0/RSP0/CPU0:router# show diag
Mon Jun 29 00:36:41.576 PST
NODE module 0/RSP0/CPU0 :
MAIN:
S/N:
Top Assy. Number:
PID:
UDI_VID:
HwRev: V4.8
New Deviation Number: 0
CLEI:
Board State : IOS XR RUN
PLD:
MONLIB: QNXFFS Monlib Version 3.2
ROMMON: Version 1.0(20081208:173612) [ASR9K ROMMON]
Board FPGA/CPLD/ASIC Hardware Revision:
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
100
board type 0x100302
FOC1230803H
68-3160-04
A2K-RSP-4G-HDD=
VP4
IPUCARJBAA
Motherboard: N/A, Processor: 0x8004 (rev: 2.2), Power: N/A
Compact Flash : V1.0
XbarSwitch0 : V1.3
XbarSwitch1 : V1.3
XbarArbiter : V1.0
XbarInterface : V0.0
IntCtrl : V1.14
ClkCtrl : V1.13
PuntFPGA : V1.5
HD : V3.0
USB0 : V77.20
USB1 : V77.20
CPUCtrl : V1.17
UTI : V1.6
LIU : V1.0
MLANSwitch : V0.0
EOBCSwitch : V2.0
CBC (active partition)
CBC (inactive partition)
: v1.2
: v1.1
Managing the Router Hardware