JAI GO-5101M-PMCL User Manual page 49

Item
Sequencer Reset
g) Digital IO Control
Line Selector
Line Mode
Line Inverter
Line Status
LineSource
Line Format
User Output Selector
User Output Value
h) Pulse Generators
Clock Pre-scaler
Pulse Generator Clock (MHz)
Pulse Generator Selector
Setting range
—
Line1 - TTL Out,
Line4 - TTL In,
Line7 - CC1,
NAND Gate 0 In 1,
NAND Gate 0 In 2,
NAND Gate 1 In 1,
NAND Gate 1 In 2
Input,
Output
True, False
True, False
Low, High,
Frame Trigger Wait,
Frame Active,
Exposure Active,
FVAL,
Pulse Generator 0,
User Output 0,
User Output 1,
Line4 - TTL In,
Line7 - CC1,
Nand 0 Out,
Nand 1 Out
—
User Output 0,
User Output 1
True, False
1 to 4096
0.018127 to 74.25
Pulse Generator 0
— 49 —
GO-5101M-PMCL / GO-5101C-PMCL
Default value
— Reset the current index number to the
number configured in [Sequencer Set
Start].
Configure settings for digital input/output.
Line1 - TTL Out Select the input/output to configure.
Output Display the input/output status (whether it
is input or output).
False Enable/disable polarity inversion for the
selected input signal or output signal.
False Display the status of the input signal or
output signal (True: High, False: Low).
Low Select the line source signal for the item
selected in [Line Selector].
TTL Display the current I/F type.
0: User Output 0 Set the user output signal.
False Set the value for the User Output selected
in [User Output Selector].
Configure pulse generator settings.
165 Set the division value for the prescaler
(128-bit length) using the pixel clock as
the base clock.
0.45 Set the clock used for the pulse
generator.
This value is calculated using the [Clock
Pre-scaler] value as a base.
Pulse Generator 0 Select the pulse generator.
Description