Table of Contents
Advertisement
Item
Pixel Format
Test Pattern
c) Acquisition Control
Acquisition Frame Rate (Hz)
Trigger Selector
Trigger Mode
Trigger Software
Trigger Source
Trigger Activation
Trigger OverLap
Exposure Mode
Exposure Time
Exposure Auto
d) Analog Control
Gain Selector
Gain
Gain Auto
Setting range
GO-5101M-PMCL:
Mono8,
Mono10,
Mono12
GO-5101C-PMCL:
BayerRG8,
BayerRG10,
BayerRG12
GO-5101M-PMCL:
Off,
GreyHorizontalRamp,
GreyVerticalRamp,
GreyHorizontalRamp
Moving
GO-5101C-PMCL:
Off,
GreyHorizontalRamp,
GreyVerticalRamp,
GreyHorizontalRamp
Moving,
HorizontalColorBar,
VerticalColorBar,
MovingColorBar
0.125 to 35.6697 (Full)
Frame Start
Off, On
—
Low,
High,
Software,
Pulse Generator 0,
User Output 0,
User Output 1,
Line4 - TTL In,
Line7 - CC1,
NAND0 Out,
NAND1 Out
Rising Edge,
Falling Edge
Off
Readout
Off,
Timed,
Trigger Width
8-bit: 14 to 7999812
10-/12-bit: 14 to 7999631
Off, Continuous
GO-5101M-PMCL:
Analog All
GO-5101C-PMCL:
Analog All,
Digital Red All,
Digital Blue All
Analog All: 1 to 16
Digital Red All and Digital
Blue All: 0.4467 to
5.6235
Off, Continuous
— 47 —
GO-5101M-PMCL / GO-5101C-PMCL
Default value
GO-5101M-
Set the pixel format.
PMCL:
[Mono12] and [BayerRG12] are enabled
Mono8
when [Video Process Bypass] is set to
GO-5101C-
[On].
PMCL:
BayerRG8
Off
Select the test image.
Configure image acquisition settings.
35.6697
Set the frame rate as a frequency. (unit: Hz)
The maximum value varies depending on
the TapGeometory and ROI settings.
Frame Start
Select the trigger operation.
Off
Select the trigger mode.
—
Execute a software trigger.
Line7 - CC1
Select the trigger signal source.
Rising Edge
Select the polarity of the trigger signal
(rising edge of
(i.e., location of signal at which trigger is
input signal)
applied).
Off
Select the trigger overlap operation.
Timed (control
Select the exposure mode.
via exposure
time)
27847
Set the exposure time.
The maximum value when [Trigger Mode]
is set to [Off] varies depending on the
[Acquisition Frame Rate Raw] value.
The minimum value varies depending on
the [Pixel Format] setting.
Off
Set whether to enable auto exposure.
Configure analog control settings.
Analog All
Select the gain to configure.
Master gain: 1
Set the gain value for the gain setting
R, B: 1
selected in [Gain Selector].
Off
Description
Advertisement
Table of Contents
