JAI GO-5101M-PMCL User Manual page 41

Changing the value of [Command Sequencer Index] to one of the other predefined indexes causes
that index to be executed in response to subsequent triggers. This mode of operation enables users to
develop applications that continually send new values to [Command Sequencer Index] in response to
external factors such as changing light conditions, different types or sizes of objects being inspected,
or other factors. This allows applications to change ROI, exposure, gain, etc., without being restricted
to a predefined pattern.
As with Trigger Sequencer, [Sequencer LUT Mode] defines whether Gamma or LUT is to be applied
to the sequence. If Gamma is selected, the Gamma setting defined in the camera's Analog Control
section will be applied to all exposures in the sequence. If LUT is selected, the LUT characteristics
defined in Analog Control will be applied to any index where [Sequencer LUT enable] has been set to
ON.
[Sequencer Index Frame Count], [Sequencer ROI Next Index], and [Reset Sequencer Index] are not
used in Command Sequencer mode and entered values are ignored.
Command Sequencer Example
User-defined Indexes (up to 128)
ROI
Exposure
Gain
LUT
Binning
Set to
Index1
Command
Sequencer
Index
Camera
Triggers
Image
Frames
Settings
Index1
Used
Settings
Index structure for Command Sequencer
Index
Selector
(MUX)
Current
Index
Common Settings
Command Sequencer Index (1 to 128)
Index1 Index2
ROI
Exposure
Gain
LUT
Binning
Set to Set to Set to
Index3 Index1 Index2
Index3 Index1
Settings Settings
Index1 ROI1 Exposure1
ROI2
Index2 Exposure2
Index128 ROI128
— 41 —
GO-5101M-PMCL / GO-5101C-PMCL
Index3
ROI
Exposure
Gain
LUT
Binning
Set to
Set to
Index1
Index2
Index2 Index1
Settings Settings
Gain1 Black
(M/Red/Blue)
Level1
Gain2
Black
(M/Red/Blue) Level2
Exposure Gain128 Black
128 (M/Red/Blue) Level128
Common Settings
Sequencer LUT mode
Index2
Settings
LUT
Binning1
(H/V) Enable1
Binning2
LUT
(H/V) Enable2
Binning128 LUT
Enable128
(H/V)