Step 3: Verifying The Camera's Connection Status; Step 4: Configuring Initial Settings For The Camera; Connecting The Camera To The Control Tool - JAI GO-5101M-PMCL User Manual

connector on the camera.

The AC adapter is not required when using PoCL.

Step 3: Verifying the Camera's Connection Status

When the necessary devices are connected and power is supplied to the camera, the power / trigger
LED at the rear of the camera lights amber, and initialization of the camera starts.
When initialization is complete, the power / trigger LED lights green.
Verify whether power is being supplied to the camera and whether the camera is operational by
checking the rear LED.
During normal status
Lit green
 For details on how to read the LEDs, see "LED status and camera status" (page 10) in the "Parts
Identification" section.
Note
If the power / trigger LED does not switch to green within minutes of supplying power, check the Camera Link
cable and other connections.

Step 4: Configuring Initial Settings for the Camera

Start Control Tool, connect the camera to the frame grabber board, and configure initial settings for the
output format, exposure, external trigger, etc.

Connecting the Camera to the Control Tool

1
Start JAI Control Tool.
Cameras connected to the frame grabber board are detected, and a window appears. If they do
not appear, right-click inside the window and select [Search for Cameras].
2
Select the camera you want to configure.
3
Check that the settings of the selected camera are displayed.
— 15 —
GO-5101M-PMCL / GO-5101C-PMCL