JAI GO-5101M-PMCL User Manual page 14

To prevent vignetting and to obtain the optimal resolution, use a lens that will cover the 11 mm
diagonal. Some lens manufacturers offer lenses with an 11 mm format. If not, a 2/3-inch lens is
recommended.
Caution
• The maximum performance of the camera may not be realized depending on the lens.
• Attaching a lens with a mount protrusion of 9.1 mm or longer may damage the lens or camera.
Note
The following formula can be used to estimate the focal length.
focal length = WD / (1 + W/w)
WD: Working distance (distance between lens and object)
W: Width of object
w: Width of sensor (sensor width is 8.5 mm on this camera)
2 Direct connection (or MP-43 tripod adapter plate)
When mounting the camera directly to a wall or other device, use screws that match the locking
screw holes on the camera. (Large: M3, small: M2, depth: 3 mm)
Use the supplied screws to attach the tripod adapter plate.
Caution
For heavy lenses, be sure to support the lens itself. Do not use configurations in which its weight is supported
by the camera.
3 Camera Link cable
Connect the Camera Link cable to the Mini Camera Link connector.
• Use a cable that supports the Camera Link standard and is compatible with Mini Camera Link
(SDR) connectors.
• Refer to the specifications of the cable for details on its bend radius.
• For details on the cable, see "2 Mini Camera Link connector" (page 9).
Caution
Secure the locking screws on the connector manually, and do not use a
driver. Do not secure the screws too tightly. Doing so may wear down the
screw threads on the camera. (Tightening torque: 0.291±0.049 N·m or
less)
4 Frame grabber board
Refer to the operating instructions of the frame grabber board, and configure settings on the
computer as necessary.
5 Computer
Use a computer that meets the following requirements.
Operating system (OS):
Microsoft Windows 7/8 32-bit/64-bit edition
CPU: Intel Core i3 or higher
Memory:
Windows 7/8 32-bit edition: DDR3, 4 GB or higher
Windows 7/8 64-bit edition: DDR3, 8 GB or higher
Graphics card: PCI-Express 3.0 or higher
6 DC IN / trigger IN connection cable
7 AC adapter (power supply) (if necessary)
Connect the AC adapter and the round connector of the connection cable to the DC IN / trigger IN
— 14 —
GO-5101M-PMCL / GO-5101C-PMCL
Secure manually.
Do not secure too tightly.