Perform A Visual Inspection - Funkwerk FT4 Operating Manual

3. Logging into the personal emergency signal centre (p. 124), Perform the sensor
test (p. 128).
If the automatic log-in procedure is programmed on your radio set, it will automati-
cally start the sensor test (work step 3) after it is removed from the charger.
?
You cannot log into the personal emergency signal centre?
Activate the trunking mode (TMO), see section „Activating the trunking mode"

(p. 63).

Repeat work step 3.
4. Fitting the tear-off cord (p. 129).
5. Affixing the radio set to your clothing (p. 129).

Done.

Perform a visual inspection

Check the radio set thoroughly and diligently every time before starting up the unit.
Check the following criteria:

Is any damage visible?

Are any impaired functions detectable?

Are all accessories properly connected and tightly seated?

Is the battery charge sufficient for the intended period of use?
Your radio set must pass the visual inspection without any suspected damage or
impairment. If you feel that your radio set might not be in proper condition, ensure
that it will not be used until a specialist has examined its condition.
TIP
Continue the start-up only if the radio set passes the visual inspection.
Personal emergency signal functions
Putting into operation
123