Functions Of The Sysmac Studio; Mc Test Run Function - Omron NJ501-1400 User Manual

4 Checking Wiring from the Sysmac Studio
4-1

Functions of the Sysmac Studio

This section describes how to use the MC test run function to check wiring and basic settings. You can
use the MC test run function in the Sysmac Studio to check wiring without any programming.
4-1-1

MC Test Run Function

The MC test run operation supports the following functions.
Category
Axis operation
4-2
Function
Deceleration A deceleration stop is performed during the MC
stop Test Run.
Servo The Servo is turned ON and OFF.
ON/OFF
Resetting The errors in the MC Function Module are
errors reset.
Jogging Jogging is performed in the positive or negative
direction.
Absolute posi-
Absolute positioning is performed.
tioning
Relative posi- Relative positioning is performed.
tioning
Homing Homing is performed using the homing parame-
ter settings.
Description
*
NJ-series CPU Unit Motion Control User's Manual (W507)
Setting/monitor item
---
---
---
Target Velocity
Acceleration/Deceleration
Target Position
Target Velocity
Acceleration/Deceleration
Jerk
Travel Distance
Target Velocity
Acceleration/Deceleration
Jerk
Homing Parameters