Homing - Omron NJ501-1400 User Manual

4-3-3

Homing

1
Set the homing parameters in the Homing Settings on the Axis Parameter Settings Tab Page.
2
Click the Homing Tab on the MC Test Run Tab Page.
The following dialog box is displayed.
3
Select the axis to home.
4
Click the Servo ON Button to turn ON the Servo.
5
Click the Apply homing parameters Button.
6
Click the
Check to see if the homing operation agrees with the settings.
Additional Information
• When you click the Homing Settings Button, the Homing Settings are displayed on the Axis
Parameter Settings Tab Page. Set the homing parameters.
• If the homing parameters were set in advance, click the Apply homing parameters Button to
apply those settings.
NJ-series CPU Unit Motion Control User's Manual (W507)
Button.
4 Checking Wiring from the Sysmac Studio
4
4-9