Common Functions For Single-Axis Control; Positions - Omron NJ501-1400 User Manual

9 Motion Control Functions
9-5 Common Functions for Single-axis
Control
This section describes the common functions used for single-axis control.
9-5-1

Positions

Types of Positions
The MC Function Module uses the following two types of positions.
Type of position
Command position
Actual position
The following figure shows the relationship between the command position and the actual position.
User program
Motion
Motion
control
control
processing
instruction
The command position and actual position share the following items.
Item
Count Mode
Position increment
Software limits
Changing the current position
Defining home
* If there is any following error before the change, the following error value is maintained in the actual position.
9-26
This is the position that the MC Function Module outputs to control an axis.
The actual position as input from the Servo Drive or encoder input.
MC Function Module
Command
position
(command units)
In-position check
Actual position
(command units)
Command position
You can set Linear Mode or Rotary
Mode.
You can set one of the following:
mm, µm, nm, inch, degree, or pulse.
You can set the range of operation
of the software.
You can change the actual position
to any desired position.
Home is either defined or
undefined.
Definition
Command position
(pulses)
Electronic
Command
gear
position
counter
Remainder
Actual position
(pulses)
Electronic
gear Feedback
counter
Remainder
The same Count Mode is used as
for the command position.
The unit is the same as the unit of
the command position.
The range is the same as the range
for the command position.
This value will be set to the same
position as the command position.
The status of home is the same as
the command position.
NJ-series CPU Unit Motion Control User's Manual (W507)
Servo Drive
Following M
Position loop
error
Velocity loop
counter
Current loop
E
Actual position
*