Zone Monitoring - Omron NJ501-1400 User Manual

Rotary Mode
• The FirstPosition can be less than, equal to, or greater than the LastPosition. If the FirstPosition is
greater than the LastPosition, the setting will straddle the modulo minimum position setting value.
• An instruction error will occur if a position beyond the upper and lower limits of the ring counter is
specified.
Valid range
Count value
0x7FFFFFFFFF
Modulo maximum
position setting value
Modulo minimum position
setting value (= 0)
LastPosition = 330°
Range in which latching
is enabled (The border
values are included.)
FirstPosition = 210°
For details on latching, refer to the MC_TouchProbe (Enable External Latch) and MC_AbortTrigger
(Disable External Latch) instructions in the NJ-series Motion Control Instructions Reference Manual
(Cat. No. W508).
9-8-4

Zone Monitoring

This function detects whether the command position or actual position of an axis is in the specified
range (zone). Use the MC_ZoneSwitch (Zone Monitor) instruction to specify the first position and last
position of the zone to check. The InZone output variable for the Zone Monitor instruction will change to
TRUE when the position of the axis enters the specified zone. You can also specify multiple zones for a
single axis. Zones can overlap.
For details on zone monitoring, refer to the MC_ZoneSwitch (Zone Monitor) instruction in the NJ-series
Motion Control Instructions Reference Manual (Cat. No. W508).
NJ-series CPU Unit Motion Control User's Manual (W507)
First Position ≤ Last Position
FirstPosition to LastPosition
0
Window
Latch enabled range
− 0 +
9 Motion Control Functions
First Position > Last Position
LastPosition to FirstPosition
Latch enabled range
FirstPosition = 330°
− 0 +
LastPosition = 210°
FirstPosition
LastPosition
Range in which latching
is enabled (The border
values are not included.)
9-67
9