Troubleshooting - ergoline SUNRISE 480 Turbo Power Operating Instructions Manual

06/2018 1019683-00
NOTE:
Occasionally, persons using the tanning device will
experience a slight reddening of the skin – usually in small
patches – after the second or third session. This redness is
often accompanied by an itching sensation. This may be
nothing more than a very limited heat 'rash' caused by heat
from the lamps within the device. It should go away within
approximately 24 hours and should not reappear. This
rashing can be lessened or prevented by applying moisturizer
lotion to the affected area after the tanning session is com-
pleted.

Follow instructions.

Increasing tanning also requires an extension of the
exposure time (= radiation time) or after a certain degree
of tanning has been achieved, a further intensification is
not possible. However, the radiation time may not be ex-
tended as desired within the scope of the permissible ra-
diation doses! Therefore, only a certain degree of final
tanning dependent on the skin type can be achieved
without endangering your health.

Inform users about proper tanning.
13.1

Troubleshooting

Software and device malfunctions are indicated by error codes, e.g. E005.
These error codes are output to the display to simplify troubleshooting:
If a fault occurs, the error code flashes on the display.

If several errors occur, the error messages are displayed alternately.

Error elimination is acknowledged by pressing the START/STOP button.

If the error cannot be cleared, contact Customer Service (see page 2) or

your local service provider
More detailed information regarding the error description and solutions is
available in the document 'Error codes' #1011831-.., which you find in the
Technical Documentation folder.
For authorized, trained and qualified staff:
For further technical description, please contact Customer Service (see
page 2).
Danger of skin injuries and skin diseases!
– The tanning device must never be used when the timer
is defective!
What to do when things go wrong
WARNING!
Operating instructions – 69/84