Cleaning And Disinfection Of Surfaces - ergoline SUNRISE 480 Turbo Power Operating Instructions Manual

How to use this device
52/84
12.15.1

Cleaning and disinfection of surfaces

Acrylic panel
Do not rub with a dry cloth – danger of scratching!
– Other cleaning agents, especially concentrated disinfectants or solvents
(e.g. Lysoform, ethyl alcohol or other liquids containing alcohol) must
never be used for cleaning. Failure to observe this voids all warranty
claims.
Acrylic panels (6) referenced in section 12.15.2 'Cleaning/disinfection
plan'
These panels are not in direct contact with the user, however they can become
soiled if the user inadvertently touches them. If these panels are left soiled for
an extended period of time, the heat and light from the tanning lamps may
cause the soiled areas to become permanently stained. Therefore we recom-
mend frequently inspecting and cleaning these panels when necessary, to
ensure the serviceable life of the acrylic.
– Remove fingerprints and other soiling carefully.
Plastic surfaces
For cleaning the remaining painted and unpainted plastic surfaces, it is best to
simply use warm water and commercially available soft chamois leather.
Never use aggressive cleaning agents containing alcohol or essential oils.
These may lead, in the long run, to damages not covered by the warranty.
During cleaning a slight discoloration of the leather cloth by the rubber seals
should be expected for production-related reasons.
Prevent damage to the acrylic glass and plastic surfaces.
– Remove rings, watches, bracelets etc. before starting cleaning work.
Lamps
Low pressure lamps can be cleaned with a damp cloth (without additional

cleaning agents) where necessary.
NOTICE