Commissioning - ergoline SUNRISE 480 Turbo Power Operating Instructions Manual

06/2018 1019683-00
Salty air! Contaminated air!
Device damage due to corrosion of the housing and electrical components.
– Do not install the device near swimming pools.
– Do not operate the device in locations with aggressive environmental
conditions (e.g. air containing chlorine).
Damage to the device possible!
Where there are great differences in temperature between the transport route
and the installation site the device may not be put into operation immediately
after being set up.
– Wait at least 2 hours before connecting the device to the power supply.
Damage to the device possible!
The device is not to be used outdoors.
Environmental conditions
Optimum ambient temperature: Between 59 °F (15 °C) and 89 °F (32 °C)

Storage temperature: Between 5 °F (-15 °C) and 140 °F (+60 °C)

Please contact the customer service department before putting the device into
operation - see page 2.
3.8.3

Commissioning

DANGER!
Damaged mains power cable!
Danger to persons through electric shock or burns.
– Only the manufacturer or specialist companies are
permitted to replace the mains power cable.
Initial commissioning will be undertaken by the manufacturer's own service
personnel or by authorized, trained and qualified staff. The device will be
handed over ready for use.
As the studio operator you are responsible for abiding by the electrical regula-
tions applicable at the installation site.
The unit incorporates special preventive measures with regard to the electro-
magnetic compatibility and must be installed and commissioned according to
the EMC instructions obtained from the assembly instructions.
If the device has not been used for a longer period of time, then it must first
be inspected by our customer service department or by another authorized
company before being put back into operation again.
NOTICE
Operating instructions – 17/84
What this device is