ergoline SUNRISE 480 Turbo Power Operating Instructions Manual page 58

How to use this device
58/84
Low pressure lamps
Danger of burns from hot lamps and device parts!
If the tanning device was operated before being switched off
and opened, lamps and housing parts may be hot.
– Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled down
sufficiently.
Replace faulty low pressure lamps immediately.

Always replace the entire set of lamps after the specified operating time.

– Turn 90° and carefully remove from the socket.
– UV low pressure lamps possess a reflector which directs the light out-
wards. The lamps must be mounted in such a way that the rear side of
the reflector is located on the device side.
– Push the pins vertically into the socket from above.
WARNING!