Table of Contents
Advertisement
10/2020
1006351-04B
NOTE:
For thorough cleaning and disinfection, the product must be
allowed to remain in contact with the surface being cleaned
and disinfected for a specified amount of time.
This specified amount of time depends on the cleaner/
disinfectant which is used. Follow the directions for use of the
cleaner/disinfectant.
After this specified application time remove remaining clean-
er/disinfectant from the surfaces of the device. Use a single-
pass paper towel.
Once the remaining cleaner/disinfectant has been removed,
perform a visual inspection for signs of any remaining clean-
ing solution, or areas still soiled. If either are remaining, re-
peat the cleaning process until a visual inspection can be
successfully completed without the need for additional clean-
ing.
If any of the components listed above cannot be successfully
cleaned and disinfected, they must be replaced.
12.15.1
Cleaning and disinfection of surfaces
Acrylic panel
Do not rub with a dry cloth – danger of scratching!
–
Other cleaning agents, especially concentrated disinfectants or solvents
(e.g. Lysoform, ethyl alcohol or other liquids containing alcohol) must nev-
er be used for cleaning.
Failure to observe this voids all warranty claims.
Acrylic panel (7) referenced in section 12.15.2 'Cleaning/disinfection plan'
This panel is not in direct contact with the user, however it can become soiled
if the user inadvertently touches it. If such panels are left soiled for an extend-
ed period of time, the heat and light from the tanning lamps may cause the
soiled areas to become permanently stained. Therefore we recommend fre-
quently inspecting and cleaning these panels when necessary, to ensure the
serviceable life of the acrylic.
–
Remove fingerprints and other soiling carefully.
Plastic surfaces
For cleaning the remaining painted and unpainted plastic surfaces, it is best to
simply use warm water and commercially available soft chamois leather.
Never use aggressive cleaning agents containing alcohol or essential oils.
These may lead, in the long run, to damages not covered by the warranty.
During cleaning a slight discoloration of the leather cloth by the rubber seals
should be expected for production-related reasons.
Prevent damage to the acrylic glass and plastic surfaces.
–
Remove rings, watches, bracelets etc. before starting cleaning work.
How to use this device
NOTICE
Operating Instructions – 51/88
Advertisement
Table of Contents
