Operator
The operator screen is by definition screen 000. This screen normally appears on the display.
The information that displays on this screen is configurable to read different parameters. The
default screen setting is for screen 0 to point to screen 092 and display the Rate, Weight, and
Total.
090 SELECT OP SCRN
SELECT SCREEN 91..95
OLD
000000
1
From 016 SETUP 3 of 4 screen, press SELECT to choose SET OPERATOR
SCREEN and press enter
2.
In 090 SELECT OP SCRN screen, type in new default screen number and press
ENTER
3.
Connect the write protect jumper JP17
4.
Save to EEPROM
5.
Disconnect the write protect jumper, JP17. This protects the information in the
EEPROM.
W-4510 Weigh Scale Technical Reference Manual
NEW
000000
Figure 30: Operator setup screens
Procedure 14: Setup operator screen
092 Ohmart WeighART
RATE
= 00000 LBS/MIN
WT.
= 00000 LBS
TOT
=000000 TONS
Setup
63