Table of Contents
Advertisement
Step 7: Saving the calibration information to EEPROM
After completion of step 6, all of the calibration information is in the RAM memory of the
Smart Pro. You must copy this data to the non-volatile EEPROM for long-term storage. On all
system re-boots, the EEPROM data copies into the RAM memory and becomes the current
configuration. Refer to page46 for information concerning the upload and download
configuration program.
1.
Connect the write protect jumper, JP17 and save to EEPROM
2.
From the 310 MEMORY BACKUP screen, press SELECT to choose EEPROM
TRANSFERS
3.
Screen 311 displays with the message, "CAUTION, PRESS HELP KEY FOR
EEPROM MESSAGE" If you press HELP, the following message displays:
"770 MAKE SURE THERE IS AN EEPROM IN U26 BEFORE USING THIS
FEATURE. PRESS HELP."
Press HELP to return to screen 311 and press ENTER to continue
4.
From 100 EEPROM SERVICE screen, choose SELECT COPY RAM TO
EEPROM
5.
Screen 102 RAM TO EEPROM screen displays. Enter 1 and press ENTER to
initiate the transfer. If a zero displays, the transfer was successful. If a one
displays, the transfer was unsuccessful
If the transfer was unsuccessful, verify that the jumper on JP17 is in place. It is
necessary to place the jumper on JP17 to enable any uploading to the EEPROM
6.
Disconnect the write protect jumper, JP17.
W-4510 Weigh Scale Technical Reference Manual
Procedure 29: Save calibration information to EEPROM
Calibration
93
Advertisement
Table of Contents
