Algorithm Data Set Up Group; Table 3-7 Algorithm Group Function Prompts - Honeywell UDC 3300 Product Manual

3.10

Algorithm Data Set Up Group

Introduction
Function prompts
Function Prompt
Lower Display
CONT ALG Control Algorithm
PIDLOOPS
PID Loop Selection
(NOTE 1)
CONT2ALG Control 2 Algorithm
(NOTE 1)
OUT OVRD Output Override Select
(NOTE 2)
TIMER Timer Enable/Disable
PERIOD* Timeout Period
START* Start Initiation
L DISP*
Lower Display Selection
*Prompt appears only when Timer is enabled.
NOTE 1: Two Loops and Cascade are only available on Expanded Model DC330E.
NOTE 2: Does not apply to Three Position Step Control.
4/00
This data deals with various algorithms residing in the controller:
• Control algorithms,
• Input Math algorithms,
• selecting the 1 or 2 PID Loops,
• Output Override,
• 2 Eight Segment Characterizers,
• the Timer function, and
• Totalizer function.
• Gain Scheduler
ATTENTION Math option (two algorithms, two characterizers,
totalizer) and Two Loops of Control are only available on Expanded
Model DC330E.
Table 3-7 lists all the function prompts in the Algorithm Set Up group.
Table 3-7 Algorithm Group Function Prompts
Function
Name
ON-OFF
PID A
PID B
PD+MR
3PSTEP
1 LOOP
2LOOPS
CASCAD
PID A
PID B
PD+MR
DISABL
HI SEL
LO SEL
ENABLE
DISABL
00:00 to 99:59
KEY (Run/Hold key)
ALARM2
TI REM (time remaining)
E time
UDC 3300 Process Controller Product Manual
Selections or
Range of Setting
Upper Display
(elapsed time)
Factory Refer
Setting to
PID A Section
4.6
1 or 2
PID A
DISABL
DISABL
00:01
KEY
TI REM
49