Table 6-4 Procedures For Changing A Running Setpoint Program - Honeywell UDC 3300 Product Manual

SP programming tips
4/00
Table 6-4 gives procedures for restarting, advancing, and changing the
current segment time or setpoint of a running setpoint program.
Table 6-4 Procedures for Changing a Running Setpoint Program
Function
Restarting a running
SP program
Advancing a running
SP program
Changing the
current segment
time or setpoint in a
running SP program
UDC 3300 Controller Product Manual
Press
to place SP PROG into HOLD mode.
RUN
HOLD
until you see X RA XXX or X SK XX.XX in
LOWER
the lower display.
DISPLAY
until you see 1 RA XX.XX in the lower
display.
If the lower display already reads 1 RA
XX.XX then press the [ ] key before
pressing the [ ] key.
to place SP PROG into RUN mode.
RUN
HOLD
to place SP PROG into HOLD mode.
RUN
HOLD
until you see X RA XXX or X SK XX.XX in
LOWER
the lower display.
DISPLAY
to select the segment number to advance to.
and
together
EXAMPLE: Change 2 SK XX.XX to 3 RA
XX.XX.
to place SP PROG into RUN mode.
RUN
HOLD
to place SP PROG into HOLD mode.
RUN
HOLD
Enter SP PROG configuration and change
the segment to the new time or setpoint
desired.
until you see X RA XXX or X SK XX.XX in
LOWER
the lower display.
DISPLAY
then
to place SP PROG into RUN mode.
RUN
HOLD
Result/Action
217