Configuration Tips; Table 3-1 Configuration Tips - Honeywell UDC 3300 Product Manual

3.4

Configuration Tips

Introduction
Function
Displaying Groups Use the SET UP key to display the Set Up groups. The group titles are listed in this
section in the order that they appear in the controller.
Displaying
Use the FUNCTION key to display the individual parameters under each group. The
Functions
prompts are listed in the order of their appearance in each group.
Scrolling
To get to a Set Up group prompt more quickly, hold the SET UP key in. To get to a
Function prompt more quickly, hold the FUNCTION key in. The display will scroll through
the parameters.
ATTENTION The prompting scrolls at a rate of 2/3 seconds when the SET UP or
FUNCTION key is held in. Also, [
backward at a rate twice as fast.
Changing values When changing the value of a parameter, you can use a single [
in to increase the rate of change. Stop pressing the key for 1/2 second, then press again to
quickly
restart at a slow rate.
When changing the value of a parameter, you can adjust a more significant digit in the upper
display by holding in one key [
The adjustment will move one digit to the left. Press the key again and you will move one
more digit to the left. (Holding the [
quickly.)
Restoring to the When you change the value or selection of a parameter while in Set Up mode and decide not
original value
to enter it, press RUN/HOLD once, the original value or selection will be recalled.
Exiting SET UP
To exit Set Up mode, press the LOWER DISPLAY key. This returns the display to the same
mode
state it was in immediately preceding entry into the Set Up mode.
Timing out from If you are in Set Up mode and do not press any keys for 30 seconds, the controller will time
out and revert to the mode and display that was being used prior to entry into Set Up mode.
Set Up mode
Key Error When a key is pressed and the prompt "KEY ERROR" appears in the lower display, it will be
for one of the following reasons:
4/00
Listed below in Table 3-1 are some tips that will help you enter the
configuration data more quickly.
Table 3-1
• parameter not available
• not in Set Up mode, press SET UP key first
• key malfunction, do keyboard test (operation)
• Individual key locked out
UDC 3300 Process Controller Product Manual
Configuration Tips
Tip
] [ ] keys will move group prompts forward or
] or [ ], and pressing the other [
] and [ ] keys down will change the value twice as
] or [ ] key. Hold the key
] or [ ] at the same time.
39