Alarms Set Up Group; Table 3-16 Alarms Group Function Prompts - Honeywell UDC 3300 Product Manual

3.19

Alarms Set Up Group

Introduction
Function prompts
Function Prompt
Lower Display
A1S1 VAL Alarm 1 Setpoint 1 Value
A1S2 VAL Alarm 1 Setpoint 2 Value
A2S1 VAL Alarm 2 Setpoint 1 Value
A2S2 VAL Alarm 2 Setpoint 2 Value
66
This data deals with the Alarms function that is available with your
controller.
There are two alarms available. Each alarm has two setpoints. You can
configure each of these two setpoints to alarm on one of several events
and you can configure each setpoint to alarm high or low. You can also
configure the two setpoints to alarm on the same event and to alarm both
high and low, if desired.
Table 3-16 lists all the function prompts in the Alarms Set Up group.
Table 3-16 Alarms Group Function Prompts
Function
Name
Value in engineering units
Value in engineering units
Value in engineering units
Value in engineering units
UDC 3300 Process Controller Product Manual
Selections or
Range of Setting
Upper Display
Factory Refer
Setting to
90 Section
4.15
10
95
5
4/00