Status Test Data - Honeywell UDC 3300 Product Manual

Lower Display
Prompt
(continued)
COUNTS1
COUNTER2
COUNTS2
COUNTER3
COUNTS3
PASSWORD
RES TYPE

4.19 Status Test Data

Introduction
146
Upper Display
Range of Setting
or Selection
TUNE2
0-9999 (1 = 1000 counts for
output relays 1 and 2)
Same as COUNTER1
Same as COUNTS1
Same as COUNTER1
Same as COUNTS1
0-9999
NONE
TIMER1
TIMER2
TIMER3
ALL TM
COUNT1
COUNT2
COUNT3
ALL CO
ALL TC
The prompts used here are for determining the reason for a controller
failure. Refer to the Section 8 – Troubleshooting in this manual for
complete information.
UDC 3300 Process Controller Product Manual
Parameter
Definition
Failsafe mode.
LOOP 2 TUNE—Number of times Loop 2 has been tuned
(manually and automatically).
Shows the value of Counter 1. Read only.
Counter 2 counts the number of times the selected event
has occurred.
Shows the value of Counter 2. Read only.
Counter 3 counts the number of times the selected event
has occurred.
Shows the value of Counter 3. Read only.
PASSWORD—Entering the designated number resets to
zero the timer or counter specified by Reset Type.
To designate a number as the password:
1. Set all timers and counters to DISABL.
2. Enter the desired PASSWORD (0-9999).
3. Select a Reset Type (next prompt). The PASSWORD
goes into effect when you press FUNC , that is, you can
use it to reset the counters and timers.
RESET TYPE—Select which timers and/or counters will
be reset to zero when the PASSWORD is entered.
NONE—No values will be reset
TIMER 1 will be reset
TIMER 2 will be reset
TIMER 3 will be reset
ALL TIMERS will be reset
COUNTER 1 will be reset
COUNTER 2 will be reset
COUNTER 3 will be reset
ALL COUNTERS will be reset
ALL TIMERS AND COUNTERS will be reset
4/00