Configuring Generic Mrp Protocol Parameters - Cisco ASR 9000 Series Configuration Manuallines

Implementing IEEE 802.1ah Provider Backbone Bridge

Configuring Generic MRP Protocol Parameters

Perform this task to configure the generic MRP protocol parameters for PBB-VPLS flood optimization.
SUMMARY STEPS
1. configure
2. mmrp-flood-optimization
3. (Optional) periodic transmit interval seconds
4. (Optional) join-time milliseconds
5. (Optional) leaveall-time seconds
6. (Optional) leave-time seconds
7. (Optional) flood-time seconds
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2
mmrp-flood-optimization
Example:
RP/0/RSP0/CPU0:router(config)# mmrp-flood-optimization
Enables the flood optimization for PBB over VPLS feature on the core bridge.
Step 3
(Optional) periodic transmit interval seconds
Example:
RP/0/RSP0/CPU0:router(config-mmrp-flood-opt)# periodic transmit interval 3
Enables periodic Multiple MAC Registration Protocol Data Units (MMRPDUs).
Step 4 (Optional) join-time milliseconds
Example:
RP/0/RSP0/CPU0:router(config-mmrp-flood-opt)# join time interval 300
Sets the join time for all active ports.
Step 5
(Optional) leaveall-time seconds
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring Generic MRP Protocol Parameters
369