Enabling Pseudowire Status; Configuring A Backup Pseudowire - Cisco ASR 9000 Series Configuration Manuallines

Implementing Point to Point Layer 2 Services
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Enabling Pseudowire Status

Perform this task to enable pseudowire status.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-status
4. commit
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters global configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router (config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3
pw-status
Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# pw-status
Enables all pseudowires configured on this Layer 2 VPN.
Note Use the pw-status disable command to disable pseudowire status.
Step 4 commit
Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# commit
Saves configuration changes to the running configuration file and remains in the configuration session.

Configuring a Backup Pseudowire

Perform this task to configure a backup pseudowire for a point-to-point neighbor.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Enabling Pseudowire Status
147