Cisco ASR 9000 Series Configuration Manuallines page 28

New and Changed VPN Features
Feature
EVPN Multiple Services
per Ethernet Segment
EVPN VPWS On
Demand Next Hop with
SR-TE
EVPN VPWS Preferred
Path over SR-TE Policy
EVPN VXLAN Ingress
Replication
L2VPN VPLS or VPWS
Preferred Path over
SR-TE Policy
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
2
Description Changed in Release
EVPN Multiple Services Release 6.3.2
per Ethernet Segment
(ES) feature allows you to
configure multiple
services over single ES.
The EVPN VPWS Release 6.3.2
On-Demand Next Hop
with SR-TE feature
enables you to fetch the
best path to send traffic
from the source to
destination in a
point-to-point service
using IOS XR Traffic
Controller (XTC).
EVPN VPWS Preferred Release 6.3.2
Path over SR-TE Policy
feature allows you to set
the preferred path between
the two end-points for
EVPN VPWS pseudowire
(PW) using SR-TE policy.
The EVPN VXLAN Release 6.3.2
Ingress Replication
feature enables the
VXLAN tunnel endpoint
(VTEP) to exchange local
and remote VTEP IP
addresses on the Virtual
Network Identifier (VNI)
in order to create the
ingress replication list.
L2VPN VPLS or VPWS Release 6.3.2
Preferred Path over
SR-TE Policy feature
allows you to set the
preferred path between the
two end-points for
L2VPN Virtual Private
LAN Service (VPLS) or
Virtual Private Wire
Service (VPWS) using
SR-TE policy.
New and Changed VPN Features
Where Documented
EVPN Multiple Services
per Ethernet Segment, on
page 553
EVPN VPWS
On-Demand Next Hop
with SR-TE, on page 650
EVPN VPWS Preferred
Path over SR-TE Policy,
on page 620
EVPN VXLAN Ingress
Replication, on page 557
L2VPN VPLS or VPWS
Preferred Path over
SR-TE Policy, on page
634