Configuring Unknown Unicast Backbone Mac Under Pbb Edge Bridge Domain - Cisco ASR 9000 Series Configuration Manuallines

Configuring Unknown Unicast Backbone MAC under PBB Edge Bridge Domain

5. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2
l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 pbb
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# pbb
Enters PBB configuration mode.
Step 4
backbone-source-address mac-address
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pbb)# backbone-source-address 0045.1200.04
Configures the backbone source MAC address.
Step 5
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Unknown Unicast Backbone MAC under PBB Edge Bridge Domain
Perform this task to configure the unknown unicast backbone MAC under the PBB edge bridge domain.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
378
Implementing IEEE 802.1ah Provider Backbone Bridge