Configuration Examples For Implementing 802.1Ah Provider Backbone Bridge; Configuring Ethernet Flow Points: Example; Configuring Pbb Edge Bridge Domain And Service Instance Id: Example - Cisco ASR 9000 Series Configuration Manuallines

Configuration Examples for Implementing 802.1ah Provider Backbone Bridge

RP/0/RSP0/CPU0:router(config-bgp)# exit
Enables EVPN address family under BGP routing process and enters EVPN address family configuration submode.
Step 7
address-family l2vpn evpn
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# address-family l2vpn evpn
Enables EVPN address family under BGP routing process and enters EVPN address family configuration submode.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuration Examples for Implementing 802.1ah Provider
Backbone Bridge
This section provides these configuration examples:

Configuring Ethernet Flow Points: Example

This example shows how to configure Ethernet flow points:
config
interface GigabitEthernet0/0/0/10.100 l2transport
encapsulation dot1q 100
or
encapsulation dot1ad 100
or
encapsulation dot1ad 100 dot1q 101

Configuring PBB Edge Bridge Domain and Service Instance ID: Example

This example shows how to configure the PBB edge bridge domain:
config
l2vpn
bridge group PBB
bridge-domain PBB-EDGE
interface GigabitEthernet0/0/0/38.100
!
interface GigabitEthernet0/2/0/30.150
!
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
398
Implementing IEEE 802.1ah Provider Backbone Bridge