Associating A Pseudowire Class - Cisco ASR 9000 Series Configuration Manuallines

Associating a Pseudowire Class

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface CEM0/1/0/9:10
Specifies the interface type and instance.
Step 6 neighbor A.B.C.D pw-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 120.120.120.120 pw-id 3
Configures the pseudowire segment for the cross-connect.
Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix
Note
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN
Step 7
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Associating a Pseudowire Class
Perform this task to associate the attachment circuit with a pseudowire class.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12. Use the commit or end command.
DETAILED STEPS
Step 1
configure
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
144
configure
l2vpn
pw-class class-name
encapsulation mpls
protocol ldp
end
xconnect group group-name
p2p xconnect-name
interface type interface-path-id
neighbor A.B.C.D pw-id pseudowire-id
pw-class class-name
Implementing Point to Point Layer 2 Services